Door Frame Metal Detector for Copper Coil, Copper Tubes, Various Copper Materials
Features:
Detected products: isolated wires with copper
Function:Prevent workers from stealing copper wire
Detection index(germany standard)/Sensitivity:2~3pcs one coins(RMB)copper=about18.3g
LCD display operation interface
Waterproof level:IP66 standard
Technical Parameters and specifications
1, Aperture/detection size:2000mm(H)X800mm(W)
2, Working environment: -30~55℃, Humidity <=95%RH
3, Ambient light interference: Measuring is undisturbed by ambient light
4, Calibration: pre-calibration, no need daily calibration after pre-calibration
5, Internal battery: discharge time is more than 6 months, the battery life is more than 5 years
6, Noise: less than 63 dBA at 1 meter
7, Internal working status diagnosis, monitoring, protection system; built-in window pollution monitor
8, Full-function operation screen: can achieve full-featured system operation interface;
9. Block diagram interface, friendly man-machine interface, display data easy to observe, clear, easy to operate;
10. Removal function: can remove variety metal,such as copper at the same time .don't need to serval times to design
11. Removal of metals type: iron, non-magnetic stainless steel, irregular shape of the metal copper wire
12. emoved copper size: adjustable.
13. Installation: can be installed in a small space and used near vibration equipment.
14. With the requirements of anti-site electromagnetic interference
15. Alarm:audible and visual alarm,or stop
16. EN 61326 (2001) (EMC-Electromagnetic Compatibility Standard) EN61010-1 (1993) (LVD-Low Voltage Directive Standard) BSEN162-2 (Hygienic Design Requirements), in line with ISO9001: 2008
17. Inspection head and system confirmation: meet HACCP, GMP requirements, with online confirmation procedures
18. Voltage:220V 50Hz;
Note:
1,The above sensitivity is the no-load effect and environmental interference in the case of no-load test value
2. Actual sensitivity depends on the use of the environment, the characteristics of the measured product (content, shape)
3. Special specifications and requirements can be based on customer needs Depth development and customization
